How to Use ViVi Stationery® Transfer Stickers

Cut out the desired design and make sure the surface is clean and dry before application.

Gently rub over the front of the sticker, especially over fine lines and small details, so the design bonds well to the clear film.

Slowly peel away the backing paper. Start with the larger parts of the design before moving to smaller details.

If any part stays on the backing paper, lay the clear film back down, press that area, and continue peeling slowly.

Carefully place the transfer sticker onto the surface you want to decorate.

For smooth surfaces such as glass or plastic, start by attaching one small edge of the design first, then use the scraper to gently push the sticker across the surface. This helps reduce air bubbles.

Press over the design to ensure it fully contacts the surface.

For most designs, light pressure with your fingers is enough. For small details, fine letters, or delicate shapes, use the included small scraper to gently rub over those areas so they transfer cleanly.

Pay special attention to the outer edges of the design, as good edge contact helps the transfer release more smoothly.

Slowly peel off the clear film to reveal the transferred design.

For best results, peel the film back at a sharp angle, almost folding it flat against the surface, rather than pulling upward. This keeps the pulling force parallel to the surface and helps prevent the design from lifting.

If any part does not transfer, place the film back down, press again, and continue peeling.